Next, look for power buttons and lid from the same settings and edit the settings to your preferences. Search for the control panel in the start menu and open it. This will enable hibernation but you won’t be able to notice the change from the command prompt so you will have to set the computer to hibernate after some time, when the power button is clicked or when the laptop lid is closed.(The same procedure can be used to disable hibernation) Type “powercfg.exe /hibernate on” and press enter.Right click on it and run as administrator.Search for command prompt in the start menu. Turn on hibernation in the following steps In case the hibernate option is not there, it’s possible that hibernation is disabled. Note: Sleep mode is similar to standby mode How to hibernate a computer?įor most computers, it’s as easy as clicking on the power icon from the Start menu and then clicking on the hibernate option. Therefore, in case the computer remains with no power to maintain the RAM state, the machine saved state is lost. This means that the computer needs some power to maintain the machine state and to wake up from sleep. Sleep mode is a state where the computer is put to a low power mode, where the system uses extremely little power to maintain the contents of the Random Access Memory(RAM).Įvery hardware component of the system is turned off apart of the RAM where the machine state is stored unlike in hibernation where the machine state is stored in the hard disk. (Advanced Configuration and Power Interface provides the operating system ability to configure hardware components into power management) What is sleep mode? Note: Hibernation and sleep are only supported if the computer’s hardware and drivers are ACPI. When the computer is switched back on, all the previously open programs and documents are restored to their last state.ĭuring hibernation, the computer does not use any kind of power and the machine is restored whether or not the computer had battery power (or a power source connected). With hibernation, the computer is completely switched off, while the machine state is stored in the non-volatile memory, in most cases the hard disk.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |